16/15

The fischer bolt anchor FBN II K is a steel anchor for cost-effective fixings in non-cracked concrete. The short version is suitable for pre-positioned installation and push-through installation. The bolt anchor is made of hot-dipped steel and is recommended for railings, handrails or consoles.

Descrição completa

Referência	507597FIS
Diamètre
Longueur
Largeur de clé (mm)	24
Longueur de filetage (mm)	64
Profondeur min. de trou de foret (mm)	104
Veja todas as especificações

Embalado por 10

Apenas embalagem completa

Especificações

Diamètre	M16
Longueur	64 mm
Largeur de clé (mm)	24
Longueur de filetage (mm)	64
Profondeur min. de trou de foret (mm)	104
Longueur (m)	120
Dimension du filetage métrique	16
Diamètre d'alésage (mm)	16
Nombre de disques	1
Dispositif de fixation	Écrou
Ancrage	Boulon d'ancrage à expansion
Nombre d'écrous	1
Montage traversant	Oui
Intégration à fleur	Oui
Montage à distance	Non
Épaisseur max. de serrage (mm)	15
Traitement de la surface de l'ancrage	Galvanisé à chaud
Avec col	Non
Fixation par outil d'extension	Non
Exécution ancre	Filetage extérieur
Marque	Fischer
Principales caractéristiques	Functioning - The FBN II is suitable for pre-positioned and push-through installation; also suitable for stand-off installation under certain conditions. - Prior to installation, place the hexagon nut in the optimal position (the drive-in pin projects by approx. 3 mm out of the hexagon nut). - When applying the torque, the cone bolt is pulled into the expansion clip and expands it against the drill hole wall. - The head embossing offers a simple control of the anchoring. - In the case of series installation, we recommend using the FABS bolt anchor setting tool.
Matière	Acier
Poids par pièce (g)	202.51
Info	d_o= Nominal diameter of drill bit. t_fix= Grip range. h_ef= Effective anchorage depth. Min. t_d= Recommended drilling depth. kN = Load in kN. The allowable load is valid for one single anchor, at cracked concrete (tensile zone) with concrete class C20/25, incl. partial safety factor γ_f= 1,4 and if the S_cr, N and C_cr, N are taken in to account. When reduction on spacing and edge distance take place a re-calculation of forces should be carried out by making use of the technical guide or calculation software, they are available on request. Final calculations should comply with the complete European Technical Approval (ETA), this approval is also available on request.
Code Douanier	Ver

Download como PDF Imprimir

Descrição

Números do artigo

Referência	507597FIS
EAN	4048962087758
UBB	500616669593
UNSPSC	31162101
Artigo do fabricante nr	507597

Download como PDF Imprimir

Faça o download do E-doc