text.skipToContent text.skipToNavigation
We’re pleased to announce the UK warehouse is now OPEN

Fischer fbn ii 10/5 (10x70) anclaje de perno k r


Article number 508010FIS
Diámetro
Longitud
Ancho de llave (mm) 17
Profundidad mín. del taladro (mm) 63
Longitud (m) 70
Tamaño de rosca (métrico) 10
Diámetro del taladro (mm) 10
View all specifications
Packed per 50
Full Box only

Specifications

Diámetro M10
Longitud 31 mm
Ancho de llave (mm) 17
Profundidad mín. del taladro (mm) 63
Longitud (m) 70
Tamaño de rosca (métrico) 10
Diámetro del taladro (mm) 10
Número de arandelas 1
Fijación Tuerca
Arriostramiento Anclaje partido
Número de tuercas 1
Instalación pasante Sí
Instalación pre-posicionada Sí
Instalación espaciada No
Espesor máx. de sujeción (mm) 5
Calidad del material anclaje Otro
Anclaje de protección de superficie Sin tratar
Con collar No
Fijación mediante herramienta expansora No
Modelo de anclaje Rosca exterior
Marca Fischer
Características clave Functioning - The FBN II is suitable for pre-positioned and push-through installation; also suitable for stand-off installation under certain conditions. - Prior to installation, place the hexagon nut in the optimal position (the drive-in pin projects by approx. 3 mm out of the hexagon nut). - When applying the torque, the cone bolt is pulled into the expansion clip and expands it against the drill hole wall. - The head embossing offers a simple control of the anchoring. - In the case of series installation, we recommend using the FABS bolt anchor setting tool.
Material Acero inoxidable
Aprobación de ETA Yes
Peso por pieza (g) 48.592
Info
  • do = Nominal diameter of drill bit.
  • tfix = Grip range.
  • hef = Effective anchorage depth.
  • Min. td = Recommended drilling depth.
  • kN = Load in kN.
  • The allowable load is valid for one single anchor, at cracked concrete (tensile zone) with concrete class C20/25, incl. partial safety factor γf= 1,4 and if the Scr, N and Ccr, N are taken in to account.
  • When reduction on spacing and edge distance take place a re-calculation of forces should be carried out by making use of the technical guide or calculation software, they are available on request.
  • Final calculations should comply with the complete European Technical Approval (ETA), this approval is also available on request.
Codigo SA

Article numbers

Article number 508010FIS
EAN 4048962091113
UBB 500616670807
UNSPSC 31162101
Manufacturer article nr  508010
Do not close this page. This message will disappear, when the page is fully loaded.